meggering

[electricguy]

I have a 1/2 duplex to quote . This Premise has aluminum wiring. a repair was done on an outlet by an unauthorized person and the tenant had the outlet fail after the repair and lost power to a whole general purpose branch circuit.Anyhow now there is a compliance order to have all the electrical inspected. one of his orders is to megger each branch circuit. would 30 mins per circuit be too low for time.

I will be using the info in the pigtail thread for the alum related issues.

[electricguy]

The AHJ has mentioned I may have to be careful as to payment with the customer , I am wondering how to word the schedule of payments

[jmsbrush]

I would try to have the place completely rewired, Al for branch circuits IMO is no good. Take very scrupulous notes on the testing.
30 Minutes per test is enough time.

[electricguy]

I also would like to be able add as a disclaimer something to the effect that if the AHJ finds that he wants more done that this would be bill @x amount per hour or quoted before starting.

[jmsbrush]

Absolutey.

[charlietuna]

Meggering this system would prove little in my opinion. I would take the time to inspect those outlets exposed to high amperages like the kitchen outlets.

[brian john]

One minute test is more than adequate.

But there is more than meggering as noted to prove anything in this case NOTHING beats a visual inspection of every device and splice.

[ohmhead]

I have a 1/2 duplex to quote . This Premise has aluminum wiring. a repair was done on an outlet by an unauthorized person and the tenant had the outlet fail after the repair and lost power to a whole general purpose branch circuit.Anyhow now there is a compliance order to have all the electrical inspected. one of his orders is to megger each branch circuit. would 30 mins per circuit be too low for time.

I will be using the info in the pigtail thread for the alum related issues.


Well a megger is to test your insulation only meaning not a connection of terminals or contact resistance or a joint .

I think 30 minutes is not enough time to open up all the joints ?
Our company many years back would take a copper to aluminum crimp and high press it on each joint or connection meaning each device .

Aluminum to copper.

The crimps where purchased from a company that supplied them just for that purpose fire insurance electrical protection .

This was done so that no device had a aluminum attached to it also you had your home owners insurance lowered if you had it inspected by the local electrical dept .

This was a service dept thing for many years here in orlando in the 70 s not a lot of alu wire branch circuits used anymore in housing .
You only see it in commercial work or service conductors in a home .

[brian john]

I think 30 minutes is not enough time to open up all the joints ?

.

I am not following your reasoning???????