bonding jumper
07-28-2005, 05:36 PM
Hello Gentlemen,
I was wondering if anybody has any experience with my situation.
4000A CT cabinet with Con Ed meter. --> Feeds a service switch 3000A. --> Service switch feeds bus with 3 taps for 3 switchboards. Two switchboards contain 4000A disconnects labled "Service Switch" and utility CT cabinets with associated Con Ed meters. One cabinet is MLO without a ct cabinet.
I have dealt with tenant sub metering before but I have never seen a utility company utilizing the same principals. Has anybody seen this previously as an accepted practice? Does anybody know if there is a way of checking to verify whether certain meters are "deduct" by looking at them?
Thanks
I was wondering if anybody has any experience with my situation.
4000A CT cabinet with Con Ed meter. --> Feeds a service switch 3000A. --> Service switch feeds bus with 3 taps for 3 switchboards. Two switchboards contain 4000A disconnects labled "Service Switch" and utility CT cabinets with associated Con Ed meters. One cabinet is MLO without a ct cabinet.
I have dealt with tenant sub metering before but I have never seen a utility company utilizing the same principals. Has anybody seen this previously as an accepted practice? Does anybody know if there is a way of checking to verify whether certain meters are "deduct" by looking at them?
Thanks