Forum: Hazardous (Classified) Locations

I am looking for sources to purchase the following components rated for Class 1 Division 1 Groups B, C and D: -Receptacle with 16 pin approximate,...

I am installing a conduit in a Class II division 1 area. The cable in the conduit will be fiber optic. Only fiber wires will be in the conduit. Will...

We recently had an install of GRC conduit running underground into a Class I Div II aircraft hangar. During the course of construction the conduits...

I have a situation where wall mounted lights are mounted with toggle bolts and there is a junction box behind the light. The lights are wired with...

Scenario: Class 1 Div. 2 Motorized valve, pump motor or solenoid supplied from 20a. or larger breaker thru LFMC with listed fittings (may or may NOT...

We are wiring an auto body shop. They have a paint stirrer that is just an open metal shelve and has a motor that will stir the paint in a closed...

We are specifying a new air compressor for use on a project in Vancouver BC. The compressor is to be located in a designated Class 1 Div. 2 area. ...

This is a duplicate of a post I made in November. I'm reposting because I received no comments on the original post which is very unusual. Is the...

We have space difficulty, not much available. Can you use SO cord with proper fittings (cable glands rated for class 1 div 1) to connect between...

NFPA 820 defines the boundaries for Class I, Division 1 & 2 areas in and around a wet well of a sewage lift station. The Conduit that route into the...

i am going to start searching about hazardous location lights-and my focus is on led lights- i have a typical 70w led lights and wanna to make it...

An air-driven pump is in a Classified Location, Class I, Div. 2. It pumps a caustic fluid but not a combustible fluid. I think the pump manufacturer...

Hi- I have a control panel mounted in a non classified area with extensions into a Class 1 Division 2 area. FYI- The classified area has gasoline...

HOW CLOSE CAN A SERVICE DISCONNECT BE TO ABOVE GROUND GASOLINE STORAGE TANKS

what type of wiring method I use in the Anesthetic area in hospital? please notice, the main raceway that will provide cables to anesthetic area is...

I am in a power house running conduit from a non hazardous room through a block wall into a hazardous coal dust location, i ran 30' of conduit to an...