waelatallah
Member
- Location
- Montreal, Quebec, Canada
Hi,
I have a couple of 500MCM cables passing in a 5inch conduit. the contractor installed a pull box and did two 90 degree bends to continue the run.
blue is the conduit. Red is the pull box.
Would he be able to pull the 500MCMs through this pull box. Is there a rule of thumb to approximate the bends allowed? would'nt it be better if he can make a 45 degree bend without the use of a pull box?
Thanks,
I have a couple of 500MCM cables passing in a 5inch conduit. the contractor installed a pull box and did two 90 degree bends to continue the run.
blue is the conduit. Red is the pull box.
Would he be able to pull the 500MCMs through this pull box. Is there a rule of thumb to approximate the bends allowed? would'nt it be better if he can make a 45 degree bend without the use of a pull box?
Thanks,