Search:

Type: Posts; User: nizak

Page 1 of 8 1 2 3 4

Search: Search took 0.50 seconds.

  1. Replies
    2$$
    Views
    130

    Would vinyl be considered a "combustible surface"?

    Would vinyl be considered a "combustible surface"?
  2. Replies
    2$$
    Views
    130

    HID wall pak installed on vinyl siding

    I was talking to a building owner today and he asked about installing wall pak lighting around the perimeter of a building that is vinyl sided. Is there any code that prohibits installing HID type...
  3. Replies
    1$$
    Views
    110

    Commercial space renovation

    I am looking into doing some renovation work on a small 4 tenant commercial space. The structure is an older large home that over time has been crudely divided into 4 small commercial spaces.Each...
  4. Replies
    12$$
    Views
    399

    oven disconnecting means

    Would like some thoughts on disconnecting means for double wall oven. Ovens come factory installed with FMC installed for wiring into a j box. FMC is only long enough to get to a j box located in...
  5. Replies
    16$$
    Views
    503

    Time clock vs contactor

    I need to install a 240 V heater (5kw). Owner wants it on a timer so that it only runs at a particular time in the early morning hours.I am debating if I should use a DP/ST time clock(T104) or...
  6. Looks like there may have been a "bar type"...

    Looks like there may have been a "bar type" fixture installed with what appear to be hollow wall anchors.If the NM cable can terminate with an approved connector inside the channel space of the...
  7. Replies
    12$$
    Views
    538

    vinyl siding blocks

    I have 2 siding contractors I work with and they both install 1" deep vinyl mounting blocks for exterior lighting.I will stub nm out and they set the block and pull wires thru. I cut out box opening...
  8. Replies
    45$$
    Views
    1,121

    water tank bonding jumper

    Is it a code requirement to bond between the hot and cold water lines on a hot water tank? If yes, could someone give me the specific language.

    Thanks.
  9. Replies
    11$$
    Views
    396

    help sizing an electric heater

    Is anyone here familiar with the sizing of a fan forced electric heater for a garage?

    Here are the particulars:
    - 11ft ceilings
    -650 sq ft
    -R19 insulation/finished drywall
    -maintain 45 degree...
  10. Replies
    3$$
    Views
    205

    hanging fixture height

    Does anyone have any suggestions on what height to hang a chandelier in a foyer with 19' ceilings. Most times there is a window that I center the fixture in so it can be seen from the outside, not so...
  11. Replies
    10$$
    Views
    616

    Have the AHJ give you the article # that he/she...

    Have the AHJ give you the article # that he/she feels the supposed violation falls under.

    I recently had an inspector tell me that all the kitchen receptacles HAD to be rated 20A because they were...
  12. Replies
    10$$
    Views
    616

    Need more info. Circuit size?? Total load of...

    Need more info.

    Circuit size??
    Total load of units combined??
  13. Replies
    19$$
    Views
    656

    No concrete encased electrode present

    Get to the job (new residential build) and no CEE present anywhere.Unfamiliar with poured wall contractor never worked with this Co. Is it a specific requirement to install it, or a specific...
  14. Replies
    20$$
    Views
    648

    Thanks much guys/gals. It's a 10' exterior...

    Thanks much guys/gals. It's a 10' exterior soffit. GFCI breaker in panel is my easiest route for this one.I totally overlooked it as the owner wanted switched receps in the soffits for Christmas...
  15. Replies
    20$$
    Views
    648

    GFCI accessability??

    Can a GFCI receptacle be installed in a soffit? Is the code for such an application accessible, readily accessible?? I realize that the device somewhere at ground level would be a greater...
  16. Replies
    23$$
    Views
    965

    The meter bank is comprised of 4 Tennant and 1...

    The meter bank is comprised of 4 Tennant and 1 house meter. It's straight forward as to what panels are being fed, you can physically see the conduits from point A to B. Meter # corresponds with # on...
  17. Replies
    23$$
    Views
    965

    Increased energy useage

    I have a customer who occupies a small commercial suite. There are 4 or 5 computers, a printer, and a dozen or so 2'x4' fluorescent lay in's along with general purpose receps throughout.On the two...
  18. Replies
    5$$
    Views
    161

    Answers my question then. Thanks for the input,...

    Answers my question then. Thanks for the input, much appreciated.
  19. Replies
    5$$
    Views
    161

    IDK. Seems that the tripped position of the...

    IDK. Seems that the tripped position of the handle is different than the "on" position.
    I am going to call Schneider tech support and talk to them.
  20. Replies
    5$$
    Views
    161

    Homeline 2 pole breaker lock

    Does anyone here use SqD Home line breaker locks?
    The product in question is a Hom 2PAL ACP.
    When I installed it on the breaker, it has the ability to actually rest in a manner that would allow the...
  21. Replies
    4$$
    Views
    227

    3 wire vs 4wire well pump

    As of late I've had several new build jobs that are in rural areas without city water. Some of the well drillers provide 3 wire( 2 power& equip ground) .75hp 230v single phase pumps which just tie...
  22. Replies
    9$$
    Views
    339

    Not subject to ADA. A conventional stat is...

    Not subject to ADA. A conventional stat is usually at 60", it just seemed like that was too high.
  23. Replies
    9$$
    Views
    339

    In floor heat thermostat height

    Does anyone here know the recommended mounting height for a thermostat controlling in floor electric heat? I have looked through a couple manufacturers install guides and they say "at an appropriate...
  24. Replies
    35$$
    Views
    1,627

    One item that usually comes up in conversation is...

    One item that usually comes up in conversation is that lights blink when a high wattage device(vaccum motor starting) is turned on.Many times an A/C condenser will cause blinking on any circuit when...
  25. Replies
    35$$
    Views
    1,627

    #14 or #12 awg/residential wiring

    Do most contractors here who mainly do residential work use #14 for general purpose receps and lighting? Do some municipalities require #12 as the minimum regardless of what load it's serving?
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4