Search:

Type: Posts; User: George Stolz

Page 1 of 8 1 2 3 4

Search: Search took 1.78 seconds.

  1. Replies
    7$$
    Views
    137

    Some just like to argue. :) Has there been a...

    Some just like to argue. :)

    Has there been a poll on that?
  2. Replies
    4$$
    Views
    240

    I think they are each their own special...

    I think they are each their own special snowflake, each brand has their quirks.

    By "special" I mean "hypertension-inducing" and snowflake could be roughly translated as "junk". :)
  3. I believe the approved GF current was .5 mA.

    I believe the approved GF current was .5 mA.
  4. Replies
    40$$
    Views
    1,646

    I think the heating and cooling, resulting in...

    I think the heating and cooling, resulting in expansion and condtraction of the conductor, due to loads cycling on and off move the conductors at the terminations the most, assuming a tightly...
  5. Replies
    30$$
    Views
    1,047

    I like spending plumber's money. :)

    I like spending plumber's money. :)
  6. Replies
    30$$
    Views
    1,047

    The conductor between the gas pipe and the...

    The conductor between the gas pipe and the grounding electrode system is not a Grounding Electrode Conductor, so it is not required to be continuous.



    That section is not relevant to what you...
  7. Get the electrician on board first. I am...

    Get the electrician on board first.

    I am closing this thread, in accordance with the Forum Rules.

    If you feel this action to be in error, feel free to contact me via PM to explain.

    A...
  8. Replies
    40$$
    Views
    1,447

    I would say no, based on the dimensions given...

    I would say no, based on the dimensions given above. It would have to be 2" "tall" in the picture you posted.
  9. Replies
    40$$
    Views
    1,447

    There's much to the section that makes no sense....

    There's much to the section that makes no sense.



    Why on earth not? It's explicitly for their use!
  10. Replies
    2$$
    Views
    225

    Welcome to the forum. :) It takes about 8...

    Welcome to the forum. :)

    It takes about 8 hours to reach a full charge on most of these appliances, so I would assume that it would draw close to nameplate for over 3 hours to get there. I would...
  11. I think it's clear that you are not being...

    I think it's clear that you are not being whimsical in your approach to this, and if it doesn't work out as hoped I would not lose sleep over it. You didn't build the lamp, your buddy didn't build...
  12. Replies
    6$$
    Views
    260

    Excellent. Thanks for the clarification. :)

    Excellent. Thanks for the clarification. :)
  13. Replies
    6$$
    Views
    260

    FACP Location

    I would like to put a Fire Alarm Control Panel on a rickety platform above a swimming pool full of sharks that is accessed by a gangplank featuring flaming hoops, which can only be accessed by...
  14. Replies
    88$$
    Views
    2,908

    In lieu of substantiation, insert cronyism. ...

    In lieu of substantiation, insert cronyism.



    So... You pigtail your devices at trim? :?

    How about you leave well enough alone. There are many different ways to skin a cat, and there is...
  15. Replies
    30$$
    Views
    919

    Really? You could have fooled me. Have you...

    Really? You could have fooled me.

    Have you read Dr. Joe Engel's paper on AFCIs?
  16. Replies
    24$$
    Views
    1,097

    Zero. And I'm strangely at ease with that. :)

    Zero. And I'm strangely at ease with that. :)
  17. Replies
    12$$
    Views
    813

    It's unlikely to route a GEC through the raceway...

    It's unlikely to route a GEC through the raceway with the circuit conductors due to complications arising from 250.64, and it would not be the "effective ground fault current path" you referred to.
    ...
  18. Replies
    12$$
    Views
    813

    In all cases there would be a green wire, I...

    In all cases there would be a green wire, I think...?
  19. Replies
    43$$
    Views
    2,117

    And quoting entire posts stinks too.

    And quoting entire posts stinks too.
  20. Replies
    12$$
    Views
    813

    Agreed. No, by not switching the neutrals you...

    Agreed.

    No, by not switching the neutrals you do not have a separately derived system, and no connection to the building grounding electrodes are required. Connecting the neutral to the equipment...
  21. Replies
    15$$
    Views
    537

    Let me throw a wrinkle in. If this run is 500'...

    Let me throw a wrinkle in. If this run is 500' long and you are using MC Cable or EMT what wire size would you use?
  22. Replies
    29$$
    Views
    1,034

    I pity the fool who puts 1/2" runs into a panel....

    I pity the fool who puts 1/2" runs into a panel. 3/4 minimum for me. :)

    I try to throw a couple spares, I usually wind up using them anyway. The biggest thing is leaving a path (via strut) and...
  23. Replies
    16$$
    Views
    666

    Uh oh. What section? :ashamed:

    Uh oh. What section? :ashamed:
  24. Replies
    11$$
    Views
    1,458

    Wasp spray for wasps, people spray for people....

    Wasp spray for wasps, people spray for people. The right tool for the right job (assuming the premium tool is not desired.)

    Can I move this to campfire? Seems kind of peripheral to the trade.
  25. Replies
    16$$
    Views
    666

    I'm leaning towards programmable stat too -...

    I'm leaning towards programmable stat too - throwing in a DP contactor if necessary.
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4