Search:

Type: Posts; User: Little Bill

Page 1 of 8 1 2 3 4

Search: Search took 0.07 seconds.

  1. Sorry, can't leave this open because: In...

    Sorry, can't leave this open because:

    In accordance with the Forum rules. This Forum is intended to assist professional electricians, inspectors, engineers, and other members of the electrical...
  2. I am closing this thread, in accordance with the ...

    I am closing this thread, in accordance with the Forum rules. This Forum is intended to assist professional electricians, inspectors, engineers, and other members of the electrical industry in ...
  3. Replies
    45$$
    Views
    952

    I don't know where you are getting that Tn (at...

    I don't know where you are getting that Tn (at one time) only allowed #12 in certain areas. We have a state wide adoption and I've never seen that requirement accept on certain job specs. But...
  4. As long as there are no cut wires or open...

    As long as there are no cut wires or open splices, it's as safe as any other wire near the gas line.

    Thread closed
  5. I haven't looked it up and never gave any thought...

    I haven't looked it up and never gave any thought to NOT using an insulated EGC for pool equipment. Since all I've ever seen required using conduit/raceway (excluding equipment that has a plug cap &...
  6. Replies
    13$$
    Views
    457

    Then he's 100% wrong.

    Then he's 100% wrong.
  7. Replies
    17$$
    Views
    550

    NEC gives no certain distance, only nearest point...

    NEC gives no certain distance, only nearest point of entry. That phrase is subjective and is always left to the AHJ to decide. Here, they don't list a distance but look at each install on a case to...
  8. Replies
    13$$
    Views
    457

    First, it depends on where the EMT is installed,...

    First, it depends on where the EMT is installed, inside or out.

    Second, and I may be wrong here, I don't think inside of conduit was considered a damp/wet location until the 2008.
  9. Replies
    7$$
    Views
    233

    That would be like wearing a belt and...

    That would be like wearing a belt and suspenders!:)
  10. Replies
    19$$
    Views
    652

    Yes, but my reply was in thinking the OP was...

    Yes, but my reply was in thinking the OP was needing to have actual 240/120 voltages.
    I might have read him wrong as he could be asking about the panel rating only.
  11. Replies
    19$$
    Views
    652

    Wait, do you have both voltages there now? If...

    Wait, do you have both voltages there now?
    If not and it's only a 208/120, you can't get 240V out of that.
  12. Replies
    7$$
    Views
    233

    No different AFCI breakers other than some are...

    No different AFCI breakers other than some are dual function as you noted with the GFCI/AFCI.

    In fear of confusing you I cautiously tell you there are some that used to have a form of GF...
  13. Replies
    2$$
    Views
    160

    The pool bonding was for equipotential bonding, a...

    The pool bonding was for equipotential bonding, a metal barn has no such requirement.

    Note: unless the barn is close to the pool!:)

    There is a section for equipotential bonding for agriculture,...
  14. Replies
    42$$
    Views
    1,813

    Hey, look at the time stamp when I posted! I was...

    Hey, look at the time stamp when I posted!
    I was just shutting down the computer, half asleep, and saw the post.
    Should have waited until I was awake before answering that!:slaphead::ashamed:
  15. Replies
    42$$
    Views
    1,813

    If the 20A receptacle is not a stand-alone and is...

    If the 20A receptacle is not a stand-alone and is part of a multi-receptacle branch circuit, then it is allowed.
    If it's a single receptacle then it has to be on a 20A breaker and the correct size...
  16. Replies
    22$$
    Views
    817

    How did we go from the OPs question about EMT to...

    How did we go from the OPs question about EMT to NM?
  17. Ok, they want fans installed where there is none....

    Ok, they want fans installed where there is none. So you are going to do them for $50 each? Let's see.....it takes an hour to locate where to cut the hole, cut hole, run wire, possibly having to cut...
  18. Replies
    1$$
    Views
    186

    I would suggest you vet the electricians you hire...

    I would suggest you vet the electricians you hire or get quotes from. Make sure they are licensed and check references.

    With that said:

    I am closing this thread, in accordance with the Forum...
  19. Replies
    12$$
    Views
    303

    See post #10

    See post #10
  20. Replies
    12$$
    Views
    303

    It was either the 2005 or 2008 that changed the...

    It was either the 2005 or 2008 that changed the allowance for 3-wire to an outbuilding. It was allowed before then but there were requirements to follow even then.
  21. Replies
    12$$
    Views
    303

    Ok, I get a feeling the inspector is correct. Now...

    Ok, I get a feeling the inspector is correct. Now waiting on the OP to come back to see what I win!
  22. Replies
    12$$
    Views
    303

    Before I state my thoughts, I need to know what...

    Before I state my thoughts, I need to know what kind of inspector, Electrical Inspector (official) or Home Inspector?
  23. Replies
    12$$
    Views
    303

    I am going to allow this thread up to the point...

    I am going to allow this thread up to the point of telling the OP how to do any work on his installation.

    That being said.... OP, where is the subpanel located?
  24. Thread: Odd

    by Little Bill
    Replies
    9$$
    Views
    484

    The fan blowing caused the GFCI to get cold. It...

    The fan blowing caused the GFCI to get cold. It was it's teeth chattering!:D

    Seriously have no clue unless the speed controller was sending something that the GFCI was picking up, like some sort...
  25. Replies
    21$$
    Views
    955

    Now we're going to have to banish you to a...

    Now we're going to have to banish you to a deserted peninsula!:)
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4