Search:

Type: Posts; User: norcal

Page 1 of 8 1 2 3 4

Search: Search took 0.73 seconds.

  1. Replies
    12$$
    Views
    367

    MC & NM cable both have the same requirements for...

    MC & NM cable both have the same requirements for protection from physical damage.
  2. Replies
    24$$
    Views
    830

    I assume you mean Murray breakers built so ON is...

    I assume you mean Murray breakers built so ON is up, a reverse of any other breaker that is mounted vertical w/ the lugs at the top. A regular breaker would have ON in the down position mounted in...
  3. Replies
    20$$
    Views
    736

    Years ago I was repairing a sprinkler & there...

    Years ago I was repairing a sprinkler & there were 3 PVC pipes close together so decided to cut the other two out of the way, big mistake, one of them had a 14/2 UF inside it, not on, or powered up...
  4. Replies
    4$$
    Views
    184

    These Multi-Breakers? If they are I see...

    These Multi-Breakers? If they are I see replacement the only option, been obsolete way too long.
  5. Replies
    26$$
    Views
    868

    Are there any spec grade tamper resistant...

    Are there any spec grade tamper resistant receptacles?
  6. It's been a while since I have ordered a I-R...

    It's been a while since I have ordered a I-R compressor, but they offered a 230/460V rated motors or for 208V a 208 (it's been a while) or 200V single voltage motor, they did not offer a tri-volt...
  7. Replies
    6$$
    Views
    335

    That breaker has "LOAD /CARGA" written at the...

    That breaker has "LOAD /CARGA" written at the bottom, that could rule backfeeding out.
  8. Replies
    7$$
    Views
    386

    Go to a PG&E office (Not a bill pay location) &...

    Go to a PG&E office (Not a bill pay location) & get a copy of their greenbook or try this: http://www.pge.com/mybusiness/customerservice/otherrequests/newconstruction/greenbook/servicerequirements/
  9. Replies
    33$$
    Views
    1,003

    Why not use a transformer?

    Why not use a transformer?
  10. The FPE issues were with the residential Stablok...

    The FPE issues were with the residential Stablok loadcenters, from what I understand the rest of their product line was fine.
  11. Replies
    6$$
    Views
    703

    This is good advice, no sense in putting your...

    This is good advice, no sense in putting your license at risk.
  12. Replies
    5$$
    Views
    184

    Isn't all modern circuit breakers "trip free" ? ...

    Isn't all modern circuit breakers "trip free" ? So holding the breaker handle should not affect tripping in a fault/ overload situation.
  13. Thread: T-12 Ballasts

    by norcal
    Replies
    10$$
    Views
    782

    Use a 4-lamp T8 ballast & T8 lamps, mixing T8...

    Use a 4-lamp T8 ballast & T8 lamps, mixing T8 lamps with T12 ballasts is a bad practice that will lead to callbacks.
  14. Thread: 3 phase panel

    by norcal
    Replies
    4$$
    Views
    359

    Is any equipment for use over 240 volts cheap? ...

    Is any equipment for use over 240 volts cheap? Should be able to find a 24 space panel pretty easy, but that is not the question.
  15. Replies
    4$$
    Views
    470

    Here is the Reloc website. ...

    Here is the Reloc website. http://www.relocwiring.com/
  16. Replies
    26$$
    Views
    1,089

    Bought a Klein when I could not find my Roto...

    Bought a Klein when I could not find my Roto Split, I don't like it either but did find the Roto split. :D
  17. It is my opinion, but I could not bring myself to...

    It is my opinion, but I could not bring myself to add ungrounded metallic Wiremold extensions to a system, which is why it was prefaced w/"IMHO".
  18. IMHO, it would need to be a non-metallic...

    IMHO, it would need to be a non-metallic extension.
  19. Replies
    35$$
    Views
    1,813

    But one does have to use a lot of "Industrial...

    But one does have to use a lot of "Industrial English" when one comes across people who did use 10AWG then to make matters worse, shallow boxes & short wire. :happysad:
  20. Replies
    14$$
    Views
    942

    Challenger was Zinsco in a former life, but most...

    Challenger was Zinsco in a former life, but most of Zinsco's issues were with plug-in breakers & their problematic aluminum bus. As much as I think that Zinsco products & their successors/ knockoffs...
  21. Replies
    13$$
    Views
    600

    That one takes care of the ground up/down debate...

    That one takes care of the ground up/down debate if they have those discussions.
  22. Replies
    9$$
    Views
    751

    When a lot of garages were unfinished around here...

    When a lot of garages were unfinished around here the way it was handled was to run the wiring overhead & then drop it down to the device, then it was drywalled covering only that stud bay containing...
  23. Replies
    9$$
    Views
    751

    MC is subject to the same requirements for...

    MC is subject to the same requirements for protection from physical damage as NM cable. See 330.12(1).
  24. Replies
    14$$
    Views
    846

    Crouse-Hinds used to list competitive makes of...

    Crouse-Hinds used to list competitive makes of breakers allowed in their loadcenters, but since Siemens got them never paid attention if that is still the case but I really doubt it. :p
  25. Replies
    34$$
    Views
    1,360

    Yikes! A product looking for a purpose.

    Yikes! A product looking for a purpose.
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4