PhaseShift
Senior Member
I have to install an 100A 480V disconnect to feed some temporary loads in the field. Near where the disconnect is I have an old 150hp motor that is not in use anymore. Can I use this motor starter and cables to feed this disconnect. All lods off of disconnect will be self protected.
The motor starter has adjustable electronic overloads. Can these overloads and starer be used to protect these cables and feed the disconnect? I would think that they already protected the cables when connected for the motor?
This will be a temporary installation.
The motor starter has adjustable electronic overloads. Can these overloads and starer be used to protect these cables and feed the disconnect? I would think that they already protected the cables when connected for the motor?
This will be a temporary installation.