1793
Senior Member
- Location
- Louisville, Kentucky
- Occupation
- Inspector
I have been asked to repair some PVC conduit that is pulling away from the building. Plastic anchors used on 1-1/4" PVC with 3 #3's. The run is about 80'. Supported from above every other "rib", about 4' apart.
I'm thinking unistrut with 3 to 4 TapCons at each of the existing strap locations. Catching both runs of conduit.
Would this work?
I'm thinking unistrut with 3 to 4 TapCons at each of the existing strap locations. Catching both runs of conduit.
Would this work?