KO seals

Status
Not open for further replies.

spectra05

Member
Location
Piedmont, NC
ok i see guys put these in all different ways. some just pop em in with out messin with the tabs. some put em in with the tabs on the outside and bend em down (which looks bad to me). and some put em in with the tabs on the inside and bend a couple of em. i cant find anything code wise with ko seals. just wonderin if there is a specific way you should put em in or an industry standard.

thanx
 

mark32

Senior Member
Location
Currently in NJ
Personally I install them with the tabs facing out and flatten them all. If the box in question is in plain view I may just replace it if it was my mistake in removing the KO.
 

cowboyjwc

Moderator
Staff member
Location
Simi Valley, CA
I don't really like when the tabs are flattened, someone may need to use that hole someday to add something and then it makes them hard to remove, but of course that's only if they are in the wall.

By the way, tabs in and if it fit's good I just leave it alone.:smile:
 
Status
Not open for further replies.
Top