MFS for a mechanical equipment

Status
Not open for further replies.

rose1981

Member
Location
TX
I have a mechanical equipment with electrical data 208V/1ph MCA-0.44 and MFS - 15. Can I use a 30A fusible disconnect connected to 20 Amp breaker in the panelboard. Is it code violation?

Thanks!
 

Smart $

Esteemed Member
Location
Ohio
You can if you put 15A fuses in the disconnect.
NOTE: You will have to run #12 from panel to disconnect... unless this part of the circuit qualifies as a feeder tap under the rules of 240.21(B).
 
Status
Not open for further replies.
Top