208V Question

Status
Not open for further replies.

marcchauvin

New member
We recently stumbled across a 208V single phase disconnect in our warehouse which is in the ideal location where we need to put some 120V service. Currently it comes into a disconnect, and consists of just the 2 lives and a neutral, with the disconnect being the ground. How can we safel make the transition to 2 120V circuits - I'm assuming I'll have to share a neutral, but should I be worried about not having a 4-wire service?
 

George Stolz

Moderator
Staff member
Location
Windsor, CO NEC: 2017
Occupation
Service Manager
I am closing this thread, in accordance with the Forum rules. This Forum is intended to assist professional electricians, inspectors, engineers, and other members of the electrical industry in the performance of their job-related tasks. However, if you are not an electrician or an electrical contractor, then we are not permitted to help you perform your own electrical installation work.

If I have misjudged the situation, if for example this project is related to your work, then send me a Private Message. If you can show me that I am wrong, and that you are a licensed electrician (or at least a licensed apprentice), then I will reopen your post, and offer an apology for the delay and inconvenience.

A reminder to all members, if you see a questionable post, feel free to report it by clicking the
report-40b.png
button at the bottom left corner of the post.
 
Status
Not open for further replies.
Top