Hello all,
I noticed some tubing installed on a job I'm on. I was wondering how you'd make these bends. Let's assume the pipe(s) on the right (there are two stacked on top of each other) are a 30deg bend at the end of the pipe. As you go left you can see that the bends were not on the end of the pipe but they pipes alittle longer. And the next pipes to the left of that (last row) are even longer still.
How would you make those bends? What I mean is how much would you know to measure to make your next row? And the row after that?
Thanks
http://www.turboimagehost.com/p/7636490/Coduits.jpg.html
I noticed some tubing installed on a job I'm on. I was wondering how you'd make these bends. Let's assume the pipe(s) on the right (there are two stacked on top of each other) are a 30deg bend at the end of the pipe. As you go left you can see that the bends were not on the end of the pipe but they pipes alittle longer. And the next pipes to the left of that (last row) are even longer still.
How would you make those bends? What I mean is how much would you know to measure to make your next row? And the row after that?
Thanks
http://www.turboimagehost.com/p/7636490/Coduits.jpg.html