ETAP Short Circuit Analysis Report Critical Error

Status
Not open for further replies.

polijb2nd

Member
Location
Philippines
Hi Can anyone help me?
I try to run Short Circuit Analysis and report shows the following critical errors.
Please see my picture below.
What could be the following solution?

Short Circuit Analysis Report.jpg
 

kingpb

Senior Member
Location
SE USA as far as you can go
Occupation
Engineer, Registered
If you selected the breakers from the library, make sure you have selected the correct ratings. You can add additional devices if they are not in the built-in library.

If the devices have been confirmed to be correct, then you need to look at your sources and make sure you have the energy input correctly. If that is all correct, then you have a breaker that is rated too low for the energy available.
 
Status
Not open for further replies.
Top