ABB ACS800 Drive fault 4210

Status
Not open for further replies.

eawebb6678

New member
Location
Texas, USA
Can anyone tell me how to bypass the drive fault for an ABB drive? The fault indication ASC800 TEMP (4210) will not let me reset it and i know for a fact that it is a false indication. Therefore, i cannot run the drive until it is corrected. This has to do with some temp sensor in the IGBT module.
 

Dennis Alwon

Moderator
Staff member
Location
Chapel Hill, NC
Occupation
Retired Electrical Contractor
Being that you are not an electrician it would not be allowed to help here. I would be afraid that some one will get hurt. Call an EC.
 

Dennis Alwon

Moderator
Staff member
Location
Chapel Hill, NC
Occupation
Retired Electrical Contractor
I am closing this thread, in accordance with the Forum rules. This Forum is intended to assist professional electricians, inspectors, engineers, and other members of the electrical industry in the performance of their job-related tasks. However, if you are not an electrician or an electrical contractor, then we are not permitted to help you perform your own electrical installation work.


If I have misjudged the situation, if for example this project is related to your work, then send me a Private Message. If you can show me that I am wrong, and that you are a licensed electrician (or at least a licensed apprentice), then I will reopen your post, and offer an apology for the delay and inconvenience.

A reminder to all members, if you see a questionable post, feel free to report it by clicking the
report-40b.png
button at the bottom left corner of the post.
 
Status
Not open for further replies.
Top