Service mast

Status
Not open for further replies.

Forseti

New member
Location
Cocoa, FL
I am relocating the meter on my home from the rear to the right side. I have 2" IMC to run up above the roof but I have hit a snag. I have a small "Lip" overhanging the side that is too short to run the IMC through it. Does the NEC allow you to put a offset bend in the service mast to go around the lip? I will have uni-strut and clamp just before the bend. Id hate to have to cut into the lip and somehow seal the drip edge with the IMC halfway in it.
 

jumper

Senior Member
I am closing this thread, in accordance with the Forum Rules.

This site is designed for:


  • Contractors
  • Electricians
  • Engineers
  • Inspectors
  • Instructors
  • Other electrically related individuals

* This NEC� Forum is for those in the electrical and related industries. Questions of a "How-To" nature by persons not involved in the electrical industry will be removed without notice.
If you feel this action to be in error, feel free to contact me via PM to explain.

A reminder to all members, if you see a questionable post, feel free to report it by clicking the
report-40b.png
button at the bottom left corner of the post.
 
Status
Not open for further replies.
Top