SimPull Romex-Anyone Have Experience?

Status
Not open for further replies.

bkludecke

Senior Member
Location
Big Bear Lake, CA
Occupation
Retired Electrical Contractor
Most of my guys run the nm into the box & then "cut up" later w/ a razor knife. It works well for them but when I roughed-in I always removed the sheath 1st for reasons already stated. I see no problem w/ either method.
 

stickboy1375

Senior Member
Location
Litchfield, CT
LarryFine said:
Yes, to me, they do. They do, however, work suprisingly well on UF.

One word of warning: don't cut anything larger or harder, or you'll curl the cutting edges.


Oh, and I always strip cable before inserting into boxes.


I use them on UF also... :smile:
 

macmikeman

Senior Member
I work blazingly fast. One reason is using a little bit of yellow 77 while installing the romex. Just a little speeds things up a whole lot, and makes even the slick romex go even better. The romex strippers in the picture are the best way to go for speed.
 
Status
Not open for further replies.
Top