Lady Engineer
Senior Member
- Location
- New Jersey
I was wondering what's the best way to mount a disconnect switch on a Bus Duct? I know there are cables that connect to the bus duct, but is there anything else I need not forget for my design?
It's a 1600 vertical bus duct, which already has a 400amp fused switch mounted to it. We are adding a new 200A switch, which will be submetered. I assume we would treat it just like the busses in a Switchboard, except they are vertical busses in a metal square compartments.
It looked like a plug in, like you said, but I wasn't sure so I thought I would ask.