wire surface print

Status
Not open for further replies.

480sparky

Senior Member
Location
Iowegia
WHat is required? Depends on the cable.

What is not required? No way that one can be answered.... I doubt anyone's computer has enough memory and bandwidth.
 

drbond24

Senior Member
Thanks for pointing out 310.11(A). That's what I was looking for.

I didn't mean not required so much as not permitted. What if the conductor had already been phase identified for a multiconductor assembly? Could it then be used instead for a single as long as the requirements in 310.11(A) are met?
 

brian john

Senior Member
Location
Leesburg, VA
What is required in my experience; is upon installation the necessary data is always tapped over, on the back side, in the conduit or rubbed off.
 
Status
Not open for further replies.
Top