More Pics (I'll Stop Now)

Status
Not open for further replies.

360Youth

Senior Member
Location
Newport, NC
I couldn't tell if the blur was my camera or the actual wiring. This panel was overdue for changeout. :D

11-30-07_0850.jpg


11-30-07_0851.jpg
 

charlie b

Moderator
Staff member
Location
Lockport, IL
Occupation
Retired Electrical Engineer
360Youth said:
I couldn't tell if the blur was my camera or the actual wiring.
It is "motion blur," an effect produced by the camera (actually, by its operator :grin: ), when the camera has time to move while the shutter is open.

Next time use a faster shutter speed. If you took the photo in all-automatic mode (no user decisions on settings), then next time make sure the flash is enabled.

Also, I think you might have been too close for the focusing abilities of your camera. You may need to stand back a bit, to allow the camera to find a focus point within its range.

Oh, I'm sorry. Were you not looking for DIY photography advice? ;) :grin:
http://www.pbase.com/cbeck/favorites&page=all
http://www.pbase.com\cbeck
 
charlie b said:
It is "motion blur," an effect produced by the camera (actually, by its operator :grin: ), when the camera has time to move while the shutter is open.

Next time use a faster shutter speed. If you took the photo in all-automatic mode (no user decisions on settings), then next time make sure the flash is enabled.

Also, I think you might have been too close for the focusing abilities of your camera. You may need to stand back a bit, to allow the camera to find a focus point within its range.

Oh, I'm sorry. Were you not looking for DIY photography advice? ;) :grin:
http://www.pbase.com/cbeck/favorites&page=all

Nah, the blurr is caused by the fact that he was wearing a flash overcoat and hood with gloves, so manipulating the camera became difficult......:grin:
 

ItsHot

Senior Member
ppe filter

ppe filter

weressl said:
Nah, the blurr is caused by the fact that he was wearing a flash overcoat and hood with gloves, so manipulating the camera became difficult......:grin:
The camera has its ppe filter on the lense. You have to love that FPE panel, reversed breakers. Pull the panel cover...turn of most of the breakers!!
 

LawnGuyLandSparky

Senior Member
charlie b said:
Next time use a faster shutter speed. If you took the photo in all-automatic mode (no user decisions on settings), then next time make sure the flash is enabled.

That panel provides it's own flash. :grin:
 
Status
Not open for further replies.
Top