Tanning Bed

Status
Not open for further replies.

electricguy

Senior Member
IS there a proper way to determine which ballast has failed in a tanning bed.
this bed is an ergoline "ambition"
supplied by JK America out of arkansas ....bed is 1 yr old

Thanks
 
Last edited:
electricguy said:
IS there a proper way to determine which ballast has failed in a tanning bed.

NOTICE: I've never worked on a tanning bed.

That said, I'd be looking for the factory wiring diagram that should show their pattern for how they feed the different tubes.

I'd be surprised if it is any more complicated than they have to make it if for no other reason than to make the assembly time as simple as possible.

Call the manufacturer and have fun.

Edit to add:
http://support.jkamerica.com/
 
Last edited:
That link I posted got me to a diagram which shows which tubes are fed by which ballast. Once you identify which tubes aren't firing (by their number system) it should be pretty simple to determine which ballast is suspect.

Don't make it more complicated than it needs to be.
 

electricguy

Senior Member
BryanMD said:
That link I posted got me to a diagram which shows which tubes are fed by which ballast. Once you identify which tubes aren't firing (by their number system) it should be pretty simple to determine which ballast is suspect.

Don't make it more complicated than it needs to be.

Thanks bryan

Sorry I saw your link earlier and just thought it was their home page .
I researched a bit earlier but i didn't see the online manuals.
this will make it easier. :)
 
Status
Not open for further replies.
Top