Carultch
Senior Member
- Location
- Massachusetts
I'm aware that metal service raceways require a bonding bushing on at least one end, and metal GEC raceways require it on both ends.
How does this apply when you have an enclosure that has either a bolt-on or built-in hub, where obviously you cannot apply a bonding bushing? While it is possible to do an external listed u-bolt bonding method, but is it required in these instances?
How does this apply when you have an enclosure that has either a bolt-on or built-in hub, where obviously you cannot apply a bonding bushing? While it is possible to do an external listed u-bolt bonding method, but is it required in these instances?
Last edited: