I have a customer that has a 240 V three phase motor that has been running fine up until yesterday. Suddenly, it starts really slowly and will trip the breaker most of the time. Once in a while it’ll start up and get to full speed and it runs fine. I don’t recall the horse power offhand but the nameplate said it was around 18 A. When it starts, it’s pulling 115 A and is slow to get up to speed. I pulled the wiring cover off the motor, thinking maybe there was a cap inside that I could replace but there are only wires. Any suggestions on what might be the problem? Nothing has changed with the wiring and the voltage on all three phases is correct.....