smoky
Member
- Location
- akron, ohio, united states
I work in a plant doing polymer extrusion.
Recently an insurance guy was walking through the plant and noticed the way we lock out the machines to clean them.
there is no real way to get a hand stuck in the extruder screw.
What are your thoughts as to whether or not this meets minimum requirements?
Should there be knife switch or contactor means of disconnect?
this is an example
Recently an insurance guy was walking through the plant and noticed the way we lock out the machines to clean them.
there is no real way to get a hand stuck in the extruder screw.
What are your thoughts as to whether or not this meets minimum requirements?
Should there be knife switch or contactor means of disconnect?
this is an example