luckylerado
Senior Member
- Location
- Lake of the Ozarks
If I have 150' run of pvc under slab, do I have to count all the sweeping bends towards my 360 degrees. There was no hot box bending.
PVC bends radius
- Thread starter luckylerado
- Start date
- Status
- Location
- Illinois
- Occupation
- retired electrician
There is nothing the specifies the radius before you start counting the degrees. The code section just says 360?. All bends count.
ptonsparky
Tom
- Occupation
- EC - retired
Don't forget those dips as the trench isn't always quite the same depth.:grin:
Just figure you have 90 deg used up before you even lay a stick. Never ever use min sized conduit for runs of any length.
Other than that, as Don says.
Just figure you have 90 deg used up before you even lay a stick. Never ever use min sized conduit for runs of any length.
Other than that, as Don says.
- Status