Hope fully picture is attached. Came across install today with main feeders terminated on lugs at bottom of panel with 250A main breaker installed. Electrician than wired primary side of 75Kva trans former from line side of main breaker. Looked up listing of Schneider Power Pact JG250A breaker and it can be revers feed if is not listed with line and load.
From a safety perspective this is an unsafe installation especially without labeling.
Are they any other NEC violations that I am overlooking.?
From a safety perspective this is an unsafe installation especially without labeling.
Are they any other NEC violations that I am overlooking.?