Riograndeelectric
Senior Member
- Location
- Lakewood Colorado
My customer would like to run this table saw on 208 volts single phase. Motor name plate ratings 1.5 HP motor 120/240V 13.6/6.5 Amps
The saw motor is listed as 120/240V only,building has 3 phase 208 Volt.
I understand most motors will operate at +/- voltage rating. Do I need to use a buck boost transformer to change the voltage to 240V or can the saw operate on 208V single phase?
http://www.ridgid.com/tools/ts3650-table-saw/
The saw motor is listed as 120/240V only,building has 3 phase 208 Volt.
I understand most motors will operate at +/- voltage rating. Do I need to use a buck boost transformer to change the voltage to 240V or can the saw operate on 208V single phase?
http://www.ridgid.com/tools/ts3650-table-saw/