mbrooke
Batteries Included
- Location
- United States
- Occupation
- Technician
Can a white #10 CU be re identified as an EGC?
Re-identifing white
- Thread starter mbrooke
- Start date
- Status
jumper
Senior Member
- Location
- 3 Hr 2 Min from Winged Horses
See 250.119.
mbrooke
Batteries Included
- Location
- United States
- Occupation
- Technician
250.119 (B) seems to say ok for multi conductor cable assemblies, but only if its in a setting where only qualified people will work on it?
jumper
Senior Member
- Location
- 3 Hr 2 Min from Winged Horses
Correct.
mbrooke
Batteries Included
- Location
- United States
- Occupation
- Technician
I guess then it would be compliant in a dwelling.
jumper
Senior Member
- Location
- 3 Hr 2 Min from Winged Horses
No, no and no. Think industrial when trying to use that section.
A dwelling is not a location where it is ensured only qualified people will service the installation.
mbrooke
Batteries Included
- Location
- United States
- Occupation
- Technician
jumper
Senior Member
- Location
- 3 Hr 2 Min from Winged Horses
You're welcome.
jxofaltrds
Inspector Mike®
- Location
- Mike P. Columbus Ohio
- Occupation
- ESI, PI, RBO
No.
200.7 Use of Insulation of a White or Gray Color or
with Three Continuous White Stripes.
(A) General. The following shall be used only for the
grounded circuit conductor, unless otherwise permitted in
200.7(B) and (C):
kwired
Electron manager
- Location
- NE Nebraska
Not true, you don't read enough handiman magazines or watch enough DIY channel, everyone is qualified in those locations:lol:
- Status