class 1, 2 and 3 wiring?
- Thread starter jgh1142
- Start date
- Status
Gregg Harris
Senior Member
- Location
- Virginia
- Occupation
- Electrical,HVAC, Technical Trainer
Start with article 725.
Your question has a lot of variables to seperate to give a specific answer.
- Occupation
- Licensed Electrician
I do that from time to time and I am never not confused.
No doubt. My usual fall back position is to do what I have gotten away with in the past.
petersonra
Senior Member
- Location
- Northern illinois
- Occupation
- engineer
article 725 is about as bad as it gets as far as being clear.
mwm1752
Senior Member
- Location
- Aspen, Colo
Tru that
qcroanoke
Sometimes I don't know if I'm the boxer or the bag
- Location
- Roanoke, VA.
- Occupation
- Sorta retired........
I gave up on understanding 725 long ago.....
Master electrician
Master electrician
I don't understand 725 and what I was looking for is class 2 wiring used for control wiring in standby generators. Is this a requirement to install this wiring inside a raceway?
Jim
Master electrician
I don't understand 725 and what I was looking for is class 2 wiring used for control wiring in standby generators. Is this a requirement to install this wiring inside a raceway?
Jim
Gregg Harris
Senior Member
- Location
- Virginia
- Occupation
- Electrical,HVAC, Technical Trainer
Not required to run in conduit but is required to be separated from other conductors.
Can you be more specific in scenario?
- Status