We have a project we are currently bidding on that has a large amount of Wiremold's " Designer Series" 4000 on it. We have done small portions of the older 4000 series but nothing in the DS. Overall the job isn't too technical, but I don't really have a good labor unit for installing. Does anyone have a rough idea on typical man hours to install it say per 10', or even per 100' assuming all of the work is about 8" above floor level, and we will be only doing the power side of the wiremold? Any input is greatly appreciated.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Estimating Wiremold DS 4000
- Thread starter ccrtech
- Start date
- Status
- Not open for further replies.
I would start with standard labor units for the 4000.
Same components....base, cover, couplings, end pieces, devices, etc...
Apply units to each component, extend, total up hours.....
I would trust this total amount of hours as at least a minimum
I'm hesitant to do that since it's been a while, and the 4000 stuff we did install was small pieces incorporated with a bunch of other work in that area.
- Status
- Not open for further replies.