adagys
Member
- Location
- SW of Chicago
I have to run a single phase 240v motor for an irrigation pump approx. 200 feet from the main panel. Does this have to be on a GFI breaker?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
voltage drop
- Thread starter adagys
- Start date
- Status
- Not open for further replies.
- Location
- Placerville, CA, USA
- Occupation
- Retired PV System Designer
Will the pump be plug and cord connected to a receptacle?I have to run a single phase 240v motor for an irrigation pump approx. 200 feet from the main panel. Does this have to be on a GFI breaker?
adagys
Member
- Location
- SW of Chicago
No, it will be connected to seal tite to a disconnect down by the pond
- Location
- Placerville, CA, USA
- Occupation
- Retired PV System Designer
No requirement for GFI and as long as the EGC is proper it should be safe. Do not rely on a local ground rod to carry fault current.
But as a design choice it may be a good idea.
A detection threshold of 6ma may lead to nuisance trips on a line that long with motor starting surges, though.
But as a design choice it may be a good idea.
A detection threshold of 6ma may lead to nuisance trips on a line that long with motor starting surges, though.
John120/240
Senior Member
- Location
- Olathe, Kansas
No, it will be connected to seal tite to a disconnect down by the pond
You could-install a GFCI breaker in your disconnect down by the pond. Clarify: Install a Spa style disconnect with a GFCI breaker.
Last edited:
- Status
- Not open for further replies.