olly
Senior Member
- Location
- Berthoud, Colorado
- Occupation
- Master Electrician
Not much on the web. how do you wire multiple 0-10 dimmable LED's on 1 dimmer switch. Do you wire it in series?
0-10 volt dimmers
- Thread starter olly
- Start date
- Status
- Location
- Placerville, CA, USA
- Occupation
- Retired PV System Designer
In series would be for a current controlled device. These are voltage controlled so they must be in parallel.
Sent from my XT1585 using Tapatalk
Sent from my XT1585 using Tapatalk
- Occupation
- Licensed Electrician
You jumper from one light fixture to the next with the dimmer wires down to the San to the 0 10V dimming switch.
Fulthrotl
~Autocorrect is My Worst Enema.~
- Occupation
- E
parallel. purple and gray's together. the dimmer switch turns them on and off, and the
purple and grays say how bright. touch purple and gray together, and they go dim.
separate and they go bright.
if purple and gray contacting don't do anything, they are dmx or eco digital fixtures.
then your 0-10 dimmer won't work.
you are screwed.
purple and grays say how bright. touch purple and gray together, and they go dim.
separate and they go bright.
if purple and gray contacting don't do anything, they are dmx or eco digital fixtures.
then your 0-10 dimmer won't work.
you are screwed.
romex jockey
Senior Member
- Location
- Vermont
- Occupation
- electrician
what? :dunce:....~RJ~
tank728
Senior Member
- Location
- New Jersey
- Occupation
- Electrician
Eco digital lights are from lutron and don't use the 0-10v in the same manner that you are used to. The purple and grey inside a lutron Eco driver is a communication bus.
And DMX is/was used in theatrical lighting on like a stage. If I'm not mistaken DMX cable is usually shielded
- Status