mstrlucky74
Senior Member
- Location
- NJ
I know I've asked this before but I can't quite get the wiring scenario.
1. There is no 120v voltage from switch to ballast/driver?
2. The 120v looks like it spiced between the driver and power pack
3. If there were no sensors where would you bring your 120v circuit...to switch or in clg.?
I only ask these questions because I've been told different things about 120v wiring is needed along with the 0-10v wiring from switch to driver/light/clg box.
THanks.
1. There is no 120v voltage from switch to ballast/driver?
2. The 120v looks like it spiced between the driver and power pack
3. If there were no sensors where would you bring your 120v circuit...to switch or in clg.?
I only ask these questions because I've been told different things about 120v wiring is needed along with the 0-10v wiring from switch to driver/light/clg box.
THanks.