not my design but, customer wants to move a blender with 20hp motor that’s wired 480v to a new location that has a 225 and 208/120 service…. I though the easiest solution was a pump panel from square d. I know a nema 3 starter says it’s good to run a 25hp at 200 volts, but everything else that is listed in specs from square d only gives voltages of 240and 480. I was thinking something like this. With 100 amp fuses. What do you guys think, have any suggestions?
20hp 480v going to 208 system.
- Thread starter Necnerd
- Start date
- Status
- Occupation
- Licensed Electrician
- Status