Approached by manufacturers?

Status
Not open for further replies.
mdshunk

mdshunk

Senior Member
Location
Right here.
Because of the fact that you participate in internet forum sites, have you ever been approached by electrical manufacturers? Approached to mention their products as a potential solution to an issue, and be compensated on a "per mention" basis? If this has happened to you in the past, how did you handle it?
 
No, never.

Maybe I should call them and see what I can get. :D

BTW this post was created with electricity running through GE breakers. ;)
 
iwire said:
BTW this post was created with electricity running through GE breakers. ;)
Click to expand...
My condolances. Had that electricity been running through Cutler-Hammer breakers, I'd understand your point better. :grin:

This was a serious question, consequently.
 
Can you guys repost please? I had knock out plugs over my eyes, so I couldn't see.

Speaking of Knock out plugs!!! Have you guys tried RACO brand plugs yet? I think you will find them to be a great choice, considering todays competitive market. They are affordable, and, with all new features, installation has never been easier! Please contact your local RACO representative today!

Anyway, no, I have never been approached.
 
I don't do endorsements any more. But then, I don't do them any less either. :D :D

I say more, but I need to go make some of those Powdermilk Biscuits. Heavens they're tasty and expeditious. Make a shy person feel that they can go out and do what needs to be done.
 
Electrical contracting can be a very stressfull job. Do you know what the professionals use to relieve this stress. Alcohol and nicotine. That's right folks nothing better than a cold Budweiser and a Camel. Forget what the Surgeon General has to say, what's he ever done for you anyway. Once you kill enough brain cells you won't worry about breathing so much. So kick back, light up and pop a top and watch all your problems disappear.

I choose to go after the major advertising bucks.
 
Last edited:
I sure enjoy participating in this forum while my house is protected with a Federal Pacific Electric panel and breakers. Hang on a sec ... lights are flickering again ... do you smell smoke?
 
I would never stoop so low as to try and get money from a manufacturer.

I specify Cutler Hammer a lot, and like their equipment. I sware it's not because they occasionally comp me equipment, take me to lunch, provide free golfing, and give me wearables. I thought they were just being friendly folks. :confused:
 
growler said:
So kick back, light up and pop a top and watch all your problems disappear.
Click to expand...
"I take a toke, and all my dreams go up in smoke!" ~ Up in Smoke ~ Cheech and Chong
 
Status
Not open for further replies.
Top