bejoyeleengineer
Member
Dear all,
I was testing the overcurrent relay (Micom P123) and was confused on how to test the Auto reclose timings. I had set the first shot dead time for 5 sec and had received the value of 5 sec from the timer. When the single phase injection kit was injeted for a fault ,the timer started and stopped the timer when a binary output which is configured for "auto reclose close command to breaker" had changed it's status, i.e closing command for the breaker. But now my concern is - how can we get the reclaim time using the timer and the injection kit.
Thanks in advance
I was testing the overcurrent relay (Micom P123) and was confused on how to test the Auto reclose timings. I had set the first shot dead time for 5 sec and had received the value of 5 sec from the timer. When the single phase injection kit was injeted for a fault ,the timer started and stopped the timer when a binary output which is configured for "auto reclose close command to breaker" had changed it's status, i.e closing command for the breaker. But now my concern is - how can we get the reclaim time using the timer and the injection kit.
Thanks in advance