Commercial steam generator

[Joseph mulherin]

From my post earlier, its the water level control and the float chamber, is there a gasket and seal rebuild kit to prevent condensation from getting into the control. The make is a steamist

Mulherin Electrical Contractors

 

[donaldelectrician]

http://www.cedarbrooksauna.com/commercial-steam-generators/



Is this the steam generator ?




Don

 

[donaldelectrician]

From my post earlier, its the water level control and the float chamber, is there a gasket and seal rebuild kit to prevent condensation from getting into the control. The make is a steamist

Mulherin Electrical Contractors

If the company dose not sell gasket kits.... I am sure that gaskets, silicon or other , will fit the need .
I used to make my own gaskets on engine rebuilds . Just get the material that fits the location ...Temp withstand ect..



Don

 

[Joseph mulherin]

Yeah I am with you on that, the condensation was getting to the water level control, they wanted to sell my uncle the whole deal for 800 bucks and I said wait a minute, a few gaskets, seals and some silicone, and maybe replace the micro switches and boom fire it up, a couple hundred at most I figure. I am in industrial maintenance and I figured it was not to complex. I think his maintenance guy should have been doing routine maintenance on the unit and it would not have happened, thanks

Mulherin Electrical Contractors