Condenser nameplate voltage question
- Thread starter sw_ross
- Start date
- Location
- New Jersey
- Occupation
- Journeyman Electrician
IMO no, generally 230 volt equipment will operate just fine on 240 volts.
- Location
- Illinois
- Occupation
- retired electrician
In general equipment with a 230 volt nameplate is intended for use on 240 volt systems.
- Location
- San Francisco Bay Area, CA, USA
- Occupation
- Electrical Engineer
See this:
Voltage Ratings: 110/115/120, 220/230/240 or 440/460/480
This subject comes up a LOT in this and other forums, so I thought it would be a good idea to make it a "Sticky" that can be found and referred to easily when it comes up. There are two "standards" for voltage in North America depending on which END of the wire you are looking at; "Distribution...
forums.mikeholt.com