Disconnect voltage and current rating

[codequestion]

Is their anything in NEC 2014 regarding disconnect voltage rating and current rating?

Sent from my SM-G935U using Tapatalk

 

[LarryFine]

That's a rather vague question. Yes, it needs to meet or exceed each number.

 

[codequestion]

That's a rather vague question. Yes, it needs to meet or exceed each number.

Is their anywhere in NEC it says needs to exceed both?

Sent from my SM-G935U using Tapatalk

 

[augie47]

as noted, way too vague a question. The Code is full of provisions for disconnects.
On a basic level, 110.3(B) and 110.4

 

[codequestion]

as noted, way too vague a question. The Code is full of provisions for disconnects.
On a basic level, 110.3(B) and 110.4

Specifically lets say I have Roof Top Unit disconnect connected to 23A, 120/208V three phase circuit with MOCP of 30 amps. Where in NEC it says I need to have disconnect voltage rating and its current raring for selection of disconnect?

Sent from my SM-G935U using Tapatalk

 

[George Stolz]

110.3, 110.4, 440-II.

 

[infinity]

Specifically lets say I have Roof Top Unit disconnect connected to 23A, 120/208V three phase circuit with MOCP of 30 amps. Where in NEC it says I need to have disconnect voltage rating and its current raring for selection of disconnect?

Sent from my SM-G935U using Tapatalk

Why ask such a vague question in the OP and then provide the specific information later? Keep doing so and all of your threads will be closed.