Find the Code Violation

Status
Not open for further replies.
iwire said:
Did you really or did you change the rules like Kirk did for his Kobayashi Maru test?:grin:
Click to expand...

Nope, I really did..but it took a lot of time to make sure I didn't click on the wrong things.

I will say some luck was involved as I was questioning of a few things.

Besides, I'm not that good at computer programming.
 
I could not really see if romex was stapled right and also found it hard to see if it had a bonding screw or not. Also i question the 2 ground bars not being connected to each other
 
I enlarged it as much as I could and still didn't see the green screw...it cost me 50 points:roll: on the connection for the ground buses, the mechanical connection via the mounting screws is all that is necessary. (I think):-?
 
Chev said:
I enlarged it as much as I could and still didn't see the green screw...it cost me 50 points:roll: on the connection for the ground buses, the mechanical connection via the mounting screws is all that is necessary. (I think):-?
Click to expand...

Point here is that the green screw should not be in. It would be far easier to inspect if panel was in front of you. I do thing there is a staple issue here.Most of the violations here are no brainers to find.
If i was the inspector on this job i would spend a few hours looking at all of his work after seeing this panel.
 
Status
Not open for further replies.
Top