sdelectric
Member
- Location
- Simi Valley, CA
I have a Generac automatic transfer switch that needs to operate reverse of its purpose. I have street power connected to where the generator is supposed to be connected. I have the generator connected to where the street power is supposed to be connected.
So the normal state of the transfer switch is to be in backup mode (down), then when the generator transfers power the switch changes to street mode(up). There is no generator connected to this transfer switch.
this transfer switch is used to control the pool panel and pumps which act as a radiator for a micro turbine generator.
if I were to change the wire positions on the digital controller to connect to the opposite magnetic relays?
So the normal state of the transfer switch is to be in backup mode (down), then when the generator transfers power the switch changes to street mode(up). There is no generator connected to this transfer switch.
this transfer switch is used to control the pool panel and pumps which act as a radiator for a micro turbine generator.
if I were to change the wire positions on the digital controller to connect to the opposite magnetic relays?