Grounding
- Thread starter rbarbrey
- Start date
- Status
bphgravity
Senior Member
- Location
- Florida
Equipment grounding conductors #6 AWG and smaller must be finished green, green with yellow stripe or be bare. #4 AWG and larger are permitted to be reidentified by an approved means. The same applies to GROUNDED conductors in Article 200.
- Location
- Massachusetts
It is worded strangely.
6 AWG and smaller has to be green or bare the entire length.
4 AWG and larger can be taped or stripped at all accessible points.
Those are the NEC requirements what is actually enforced is usually another story.
6 AWG and smaller has to be green or bare the entire length.
4 AWG and larger can be taped or stripped at all accessible points.
Those are the NEC requirements what is actually enforced is usually another story.
- Status