led high bay

Status
Not open for further replies.

jhillock

Member
Location
United States
from the previous question about disconnects on cord connected high bays. the inspector asked for disconnects on the lights , But what I think he was trying to say was that they need to be plug cap connected.410 .62 I would prefer to leave them hard wired because of the enviroment can anybody make a case for this.
 

Electric-Light

Senior Member
from the previous question about disconnects on cord connected high bays. the inspector asked for disconnects on the lights , But what I think he was trying to say was that they need to be plug cap connected.410 .62 I would prefer to leave them hard wired because of the enviroment can anybody make a case for this.

just like HID and fluorescent, :lol: LED, needs a safe way to isolate for driver replacement. You could use a set of ballast quick disconnect. They're like line voltage rated battery connector for remote control cars.
 
Status
Not open for further replies.
Top