• We will be performing upgrades on the forums and server over the weekend. The forums may be unavailable multiple times for up to an hour each. Thank you for your patience and understanding as we work to make the forums even better.

Maple Systems HMI5103L setup

Learn the NEC with Mike Holt now!
Status
Not open for further replies.

kchap

Member
I need to set the IP address on a Maple Systems HMI5103L. This is the first time I have worked on one of these. The documentation describes an arrow button in the lower right-had corner of the screen used for accessing the setup screens. It says the visibility of this arrow can be enabled and disabled using either dip switches or jumpers on the back of the unit, but this one does not have either. Was the documentation I read out of date? Is there another way to access the setup screen, or is there a way to set the IP address through EBPro? Thanks!
 

PaulMmn

Senior Member
Location
Union, KY, USA
Occupation
EIT - Engineer in Training, Lafayette College
I'm assuming this is a touch screen. It sounds as if the 'button' is a touch-sensitive spot, and may be enabled at all times, with the arrow only being visible depending on the dip/jumper settings. If you touch that spot does a service screen appear?
I found this link to a setup document: https://www.google.com/url?sa=t&rct...llationGuide&usg=AOvVaw3aamOYHXvl1aZDpcQ1VWU2
It's a PDF that includes some wiring diagrams for the panel.
 
Status
Not open for further replies.
Top