NEC 760 apply

Status
Not open for further replies.
H

hhsting

Senior Member
Location
Glen bunie, md, us
Occupation
Junior plan reviewer
I have CX PS10UL please see attached below link:


Page 3 shows NO, NC contacts Fire alarms control panel FACP at the bottom.

Attached sketch shows that Fire Alarm addressable Interface Module will be connected to CX PS10UL to those NO or NC contacts with 2#14.

Fire Alarm address interface module goes to Fire Alarm Control Panel.

716bb6ccc8249416cb2ac6a610705d65.jpg



The CX PS10UL is powered from 120V branch circuit receptacle or direct hardwired.

I was wondering would the NEC 2014 section 760 apply to the power of CX PS10UL?
 
hhsting said:
I have CX PS10UL please see attached below link:


Page 3 shows NO, NC contacts Fire alarms control panel FACP at the bottom.

Attached sketch shows that Fire Alarm addressable Interface Module will be connected to CX PS10UL to those NO or NC contacts with 2#14.

Fire Alarm address interface module goes to Fire Alarm Control Panel.

716bb6ccc8249416cb2ac6a610705d65.jpg



The CX PS10UL is powered from 120V branch circuit receptacle or direct hardwired.

I was wondering would the NEC 2014 section 760 apply to the power of CX PS10UL?
Click to expand...

Let me give you all background:

I have door between sales floor and back room in egress path which requires alarmed panic hardware in Mercantile commercial setting. The door has push bar on sales side, power supply Camden CX PS10 UL please see below its manual:


In manual Page 3 shows NO, NC contacts Fire alarms control panel FACP at the bottom. The manual also says to install per 760.

The attached sketch post#1 shows that Fire Alarm addressable Interface Module will be connected to CX PS10UL to those NO or NC contacts with 2#14. The module then goes to FACP.

The CX PS10UL shows its powered by 120V circuit.

I am wondering if anyone please please help if they wired which section would 760 apply only from FACP to Module to CX PX10UL or 760 would apply to power supply brought from 120VAC supply CX PX-0UL or both? Please can anyone help?
 
hhsting said:
Let me give you all background:

I have door between sales floor and back room in egress path which requires alarmed panic hardware in Mercantile commercial setting. The door has push bar on sales side, power supply Camden CX PS10 UL please see below its manual:


In manual Page 3 shows NO, NC contacts Fire alarms control panel FACP at the bottom. The manual also says to install per 760.

The attached sketch post#1 shows that Fire Alarm addressable Interface Module will be connected to CX PS10UL to those NO or NC contacts with 2#14. The module then goes to FACP.

The CX PS10UL shows its powered by 120V circuit.

I am wondering if anyone please please help if they wired which section would 760 apply only from FACP to Module to CX PX10UL or 760 would apply to power supply brought from 120VAC supply CX PX-0UL or both? Please can anyone help?
Click to expand...

No one has any opinion?
 
Status
Not open for further replies.
Top