Need Fuji VFD help

[vinnygalbo]

Hi,

I have a Fuji Mini variable frequency drive and need to know what the parameters are to program it. It has 15 functions 0 - 9 and a - f.

Do any of you know what the values for the functions should be or perhaps you could suggest where I could find these values?

I sure appreciate any help or advice.

 

[petersonra]

have you considered reading the manual? or calling tech support?

http://americas.fujielectric.com/products/drives/

 

[mike_kilroy]

have you considered reading the manual? or calling tech support?

http://americas.fujielectric.com/products/drives/

Perhap Petersonra's link is too vague for you?

http://americas.fujielectric.com/fecoa_products/frenic-mini-c2/

What more could you want or need???

 

[Jraef]

Huh, one of my fellow mods must have not liked my earlier answer. I didn't intend on it being snarky, I'll try again in a different order of words.

Read the first paragraph of appendix A. You can't change the control mode unless you go into Advanced Programming mode, the instructions for which are in the full manual, not the Quick Start manual.

 

[petersonra]

Huh, one of my fellow mods must have not liked my earlier answer. I didn't intend on it being snarky, I'll try again in a different order of words.

Read the first paragraph of appendix A. You can't change the control mode unless you go into Advanced Programming mode, the instructions for which are in the full manual, not the Quick Start manual.

you? snarky? I don't believe it.

although I must admit when people ask questions that are readily answerable only by reading the manual, it is a bit annoying. It is not like anyone here could just rattle off the answer without looking it up themself.