Zzims
New User
- Location
- Kuala Lumpur
Good evening everyone,
First post. Short intro. Name is Zim, I am from Malaysia. Engineering Officer currently working in the Malaysian Electrical Industry. Responsible in design and development of Feeder Pillars and Compact Substation Units.
And to proceed.
Currently in the works in designing a Neutral Disconnector Switch for my Feeder Pillar and LV Board (CSU). However, I am unable to find satisfactory general technical specification and requirements to have some sense as to build a foundation. Local authorities are a little short on the details. Our BS Type Neutral Disconnector Switch was not approved. Reasons unknown to me. As they were short on the details on that too.
Has anyone here had any experience in such matters? Company not using the NEC but IEC. But any advice and suggestion would be greatly appreciated. Thanks!
First post. Short intro. Name is Zim, I am from Malaysia. Engineering Officer currently working in the Malaysian Electrical Industry. Responsible in design and development of Feeder Pillars and Compact Substation Units.
And to proceed.
Currently in the works in designing a Neutral Disconnector Switch for my Feeder Pillar and LV Board (CSU). However, I am unable to find satisfactory general technical specification and requirements to have some sense as to build a foundation. Local authorities are a little short on the details. Our BS Type Neutral Disconnector Switch was not approved. Reasons unknown to me. As they were short on the details on that too.
Has anyone here had any experience in such matters? Company not using the NEC but IEC. But any advice and suggestion would be greatly appreciated. Thanks!