Pool bonding

Status
Not open for further replies.
R

Radar0551

Member
Location
Iowa
Occupation
Inspector
Is there a good way to bond the aluminum covers that go over the auto cover on a in ground pool?

Sent from my SM-A516U using Tapatalk
 
I inspected a pool today that the case that stores the cover and drive components was made from fiberglass. Jw attached the motor lug that has a jumper to the cover so that is done, but the two aluminum panel covers have no attachment point for bonding. Is there a good way to accomplish this?

Sent from my SM-A516U using Tapatalk
 
Status
Not open for further replies.
Top