Pool sub panel feeder.

Status
Not open for further replies.
N

nizak

Senior Member
Pool Sub Panel.

Looking to install a 100 amp Single phase sub panel for pool equipment at a residence.

It will be located approx.150' from the service . That's the actual route of the conductors up, down, across, etc.

Just looking for opinions on the use of AL MC cable for the feeder.

Since an insulated equipment ground is required, this to me would appear to be the most economical and easiest to install.

It's a new build so wall cavities and attic space are both accessible.

Thanks for any suggestions.
 
I should have clarified.

The sub panel feeding the pool equipment will be located inside the residential garage and ALL equipment supplied by it will be outside.

I did not figure by definition the garage interior would be a corrosive environment.

Am I missing something other than the corrosive environment?

Thanks
 
Status
Not open for further replies.
Top